"The revised prototype is done and has been test fit and works great. We tried a little experiment and took a new one and put the bushing end (where they like to break) in a vise and by hand you could break it. We then took the improved one and had to use a crescent wrench and bend it back and forth 4 times before it finally broke.
They are milled out of a piece of 2024 Aluminum and will be powder coated black. You have to remove your original plastic bushings and transfer them to the new ones. The cost of the BMW ones are listed at $62.00 each. The cost of these are $40.00 each plus shipping.
Contact info is:
Don Westra
West Tool & Design Inc.
1220 North Tower Road
Fergus Falls, MN 56537
Phone: 218-739-4990
Fax: 218-739-4989
email: Don@westtoolff.com
Website: http://www.westtoolff.com
Don said e-mail orders would be probably the easiest and they are set up to take Visa and Mastercard."
